How To Put Down Wood Flooring

Solid hardwood flooring is the most difficult of all to install. Nail Down Staple Down The Hardwood Floors After you done installing the first line successfully its time to start installing the rest of the floor For the next rows installation just lay down the pieces connect them and nail down staple down them to the sub floor using nails gun or a stapler pneumatic or manual.

How To Install Hardwood Flooring For Beginners Youtube

When laying the second row ensure that short end joints are at least 150mm apart.

How to put down wood flooring. For your first row face the tongue of the plank towards the center of the room. It is available prefinished and can be nailed or glued down. Its usually attached with a special flooring nailer then sanded with a drum type.

Set the block of wood next to the new board. Nails should be used every 200mm or a minimum of 2 nails on boards shorter than 400mm. If you love solid wood floors and your home rests on a concrete slab youre not out of luck.

Heres how to install hardwood floors using the nail-down method. Take another piece of laminate and insert the shorter tail on this piece into the groove on the first board. Wood planks to the plywood.

We caution against the Plastic Sheet Method for testing moisture levels in your concrete slab. Place spacers inside the expansion gap the space between the wall and floor that allows the wood to expand from heat and humidity. Then install the first row of flooring with the tongue facing away from the wall and fit in place by using the flooring nailer.

Wood floor over concrete details Lay a plastic moisture barrier and then screw 34-in. It consists of a thin veneer of hardwood glued to a substrate made of wood plies much like plywood. Plywood to the concrete.

Installing Solid Wood Flooring Onto Concrete. Tap on this with the hammer to ensure the two boards are seated firmly. Insert the tongue into the groove in the board and press down until you hear the board click into place.

Put a 34-inch spacer against the adjoining wall and slide the end of the board against it. Predrill nail holes 14 inch from the narrow side of the plank at 12 inch from the wall. Then pre-drill and nail the planks down with finishing nails about 1 inch away from the wall and 3-4 inches apart.

Align the first board with the layout line with the tongue facing into the room. Drill pilot holes into the face of the first board. Continue at 6-inch intervals for the length of each board.

Lay the section on the concrete slab and use moisture-resistant tape to tape all four sides to the floor. This method requires you taping a 16-inch square piece of clear plastic at least 6 mils thick to the floor. Some types like Lyptus Flooring even lock together without fasteners similar to a laminate floor.

Place spacers to create a perimeter around the room leaving a ¼ gap between the wall and planks.

How To Choose Install Hardwood Floors A Complete Guide Architectural Digest